Click here to download the 300 Watt Solar System Diagram
This 300 Watt Solar System uses two 150 Watt solar panels wired in series. This size system pairs well with a 150Ah LiFePo4 Battery, or 200 to 300Ah of AGM Batteries.
Components List
Main Components
- 30A MPPT Solar Charge Controller
- 1000W Power Inverter
- DC Fuse Panel – Wire your DC circuits under 30A through this Fuse Panel
Solar Array
- 150 Watt Solar Panels
- 10 AWG Solar Cable – 20′ of Solar Cable with MC4 connectors on one end
- Solar Disconnect – Main Switch to disconnect the Solar Array
- Solar Cable Entry Gland – Entry gland with MC4 connectors and wire already attached
- Solar Panel Glue on Mounts
Battery Bank
- 100A LiFePo4 Battery – (Recommended Option)
- 100A LiFePo4 Battery – (Budget Option)
- 200A AGM Battery – (Budget Budget Option) Important– If using AGM batteries you’ll need twice the capacity since these batteries should not be discharged below 50% capacity.
- Main On/Off Switch
- Battery Monitor and Shunt
Everything else
For everything else needed to complete your project, please visit our Installation Components Page. There you’ll find all of the fuses, breakers, busbars, wires and tools you’ll need for this project.
Installation Guide
For detailed instructions on how to build and install this system, please read our Solar System Installation Guide.
Component Information
Power Inverter
A power Inverter converts DC electricy (from your batteries) into AC electricty. AC electricity is used to power typical household appliances. If you don’t plan to use household appliances, then you won’t need to install a power inverter.
This design uses a 1000 Watt Power Inverter, but feel free to use a smaller inverter or skip the inverter altogether if you don’t need to power A/C devices. If you wish to install a larger inverter, you’ll need to recalculate your cable and fuse sizes. Read our Guide to Wire Selection or Guide to Fuse Selection.
If you plan to plug in at campgrounds, we recommend installing an Inverter/Charger. Inverter/Chargers have a built-in battery charger and transfer switch, which allows you to plug into campground poles or normal household outlets.
DC-DC Charger
A DC-DC Charger let’s you generate power on demand, whenever you’re engine is running. So if you do alot of driving or you’re planning to do winter vanlife and you want a backup charging method, do yourself a favor and install a DC-DC Charger.
- 30 Amp DC-DC Charger For campervans and trucks
- 18 Amp DC-DC Charger For smaller engine vehicles
Solar Charge Controller
We recommend installing the Victron 100|30 MPPT Solar Charge Controller for this solar system. You can however, choose any charge controller you want as long as it’s specifications meet or exceed the Victron 100|30.
Solar Panels
This design uses two 150 watt Watt Solar Panels. These are “12 Volt” solar panels, which have a Voc of around 20 Volt, plus or minus a few volts. Check the back of your panels for a Voc rating, make sure it falls between 16 to 24 volt. Anything higher is not compatible with this design.
The solar panels are to be wired in series for this design. If you wish to wire them in parallel you’ll need to fuse each panel accordingly and recalculate solar cable sizes. Read more about When to Wire Solar Panels in Series or Parallel here.
How much solar will you install?
Discover the perfect solar system size for your Van or RV with my FREE E-book!
Other Useful Resources
Browse our other 12-Volt Systems
Leave a Reply