Our work is supported by affiliate commisions

How to Size Fuses in Your Camper Electrical System


In this article you will learn how to properly size fuses in your solar system.

Fuses protect the wires in your camper’s electrical system from over heating, melting, and then lighting on fire. They are not intended to protect the devices that you install (devices should have internal protection).

Fuses must have a lower amperage rating than the wires they are protecting, however their rating must still be higher than the devices you’re trying to power (otherwise the fuse may trip prematurely).

Before trying to calculate fuse sizes yourself

More often than not, component manufacturers list the required fuse size, wire size, and maximum wire length in the instruction manual.

Fuse and cable sizes are clearly listed by Renogy, the manufacturer of this DC-DC charger

Above is taken from the instruction manual of a DC-DC charger. Fuse and cable sizes are clearly listed. In this case, follow their guidelines and you will have no doubts.

How to calulate fuse size manually

If there are no guidelines to follow from the manufacturer, you can use this simple formula to calculate the required fuse size.

Device Amperage * 1.25 = Approximate Fuse Size

Once you have this number, you’ll need to round to the nearest available fuse size. If you round down, make sure the fuse is still large enough to power the device. If you round up, be sure the fuse rating is still lower than the cable’s rating.

Here is an example in practice

In this example we have a component that has a nominal amperage* or 13A.

If we multiply 13 * 1.25 we get 16.25, the approximate fuse size for this system.

Since they don’t manufacture 16.25A fuses we’ll have to round to the nearest available fuse size.

In this case, a 15A fuse is still large enough to power our 13A component.

Important!

Now that you have your fuse size, you have to check that the fuse rating does not exceed the maximum ampacity of the wire you’re trying to protect. This information can be found from the wire manufacturer or by using an ampacity chart.

Where to place fuses in your electrical system

For a typical camper van electrical system, fuses should be installed on the positive cable closest to the source. Each individual circuit requires protection.

The following diagram shows a typical circuit design that you will find in a camper electrical system.

In this circuit, the main positive cable is fused closest to the battery. If there is an over current after the fuse, the fuse will blow, disconnecting all of the wiring and components.

The section of cable between the power source and the fuse will still have power, for this reason, that section should be as short as possible.

Hochstromsicherungen

Fuses and Useful Components

The following fuses are safe to use in electrical systems up to 32V.

We also have Free Solar Plans!

100-Watt Minimalist System This minimalist solar system is good for those who need to power laptops, cell phones, and small devices. Learn more…
400-Watt #Vanlife System The standard #Vanlife solar system. Good for traveling full-time with moderate energy needs. Learn more…
800-Watt Super-Sized This super-sized solar system is for those who want to feel at home on the road. About the maximum amount of solar that fits on a van. Learn more…

Browse our other 12-Volt Systems

If you’ve found this website helpful please consider showing your support. Thank you!